

YOU CAN NOW ADD A CUSTOM NAMEPLATE TO YOUR ORDER HERE
The PK1 Extreme Stand for Blackmagic Design ATEM Mini Extreme / ISO. Deck out your ATEM Mini Extreme with this stand designed by Aaron Parecki.
Comes with assembly materials, assembly instructions and extra soft rubber feet. Assembly takes only a few minutes.
*Images shown are for illustrative purposes only. This product does not include the ATEM Mini Extreme, ATEM Mini Extreme ISO, SmallRig Accessories or any other hardware.
Due to COVID-19 and Christmas, longer delivery times are being experienced by our shipping partners
Returns accepted for faulty products within 14 days. Please contact us for RMA
You can attach a wide range of accessories to your stand using mounting points along the sides, back and top.
You can attach wireless mic receivers and other accessories directly to the top cross bar as it has a built in cold shoe mount.
The top "cheese bar" can hold a SmallRig monitor mount to attach a 7" or 10" monitor on top of the ATEM Mini Extreme.
There are two rear cold shoe mounts as well as screw holes for attaching various SmallRig plates or other accessories.
With a SmallRig cheese plate attached, you can mount various accessories on the side.
You can even place another ATEM Mini Extreme in front of the raised Extreme since the stand raises the ATEM Mini Extreme just enough.
The cables from the lower ATEM Mini Extreme will run underneath the PK1 Extreme Stand to keep your desktop clean. Use short slim HDMI cables to keep the cables in the rear clean.
You can also place a Stream Deck XL below the ATEM if you're using it with Companion.
The optional rear support foot provides additional stability when using larger monitors or attaching a lot of accessories to the rear cold shoes.
The optional retaining clips hold the ATEM Mini Extreme firmly in place so that it can't fall off the stand. This is great if you have heavy HDMI cables or want to mount the stand at an angle.
You might also like
YOU CAN NOW ADD A CUSTOM NAMEPLATE TO YOUR ORDER HERE
The PK1 Extreme Stand for Blackmagic Design ATEM Mini Extreme / ISO. Deck out your ATEM Mini Extreme with this stand designed by Aaron Parecki.
Comes with assembly materials, assembly instructions and extra soft rubber feet. Assembly takes only a few minutes.
*Images shown are for illustrative purposes only. This product does not include the ATEM Mini Extreme, ATEM Mini Extreme ISO, SmallRig Accessories or any other hardware.